Sony LBT-D117CD Car Stereo Manual

The Sony LBT-D117CD is an in-dash car stereo system featuring AM/FM radio, CD player, and cassette deck with auto-reverse. It includes a built-in amplifier, front/rear preamp outputs, detachable faceplate security, bass/treble controls, loudness function, and seek/scan tuning. Compatible with 12V DC vehicle power systems. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Playing Media 8. Security Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Main unit with CD player and cassette deck, Remote Control, Wiring harness, Antenna connector, Front/Rear preamp outputs, Detachable faceplate.

Feature	Description
AM/FM Tuner	30 station presets (18 FM, 12 AM) with seek/scan
CD Player	Plays audio CDs, CD-R, CD-RW with anti-shock memory
Cassette Deck	Auto-reverse playback with Dolby B noise reduction
Power Output	50W x 4 max (MOSFET power amplifier)
Preamp Outputs	Front and rear RCA outputs for external amplifiers
Security	Detachable faceplate with carrying case
Audio Controls	Bass, treble, balance, fader, loudness
Display	Fluorescent display with dimmer control
Power Source	12V DC negative ground vehicles
Clock	Digital clock with sleep timer

Installation

Unpack and inspect contents. Ensure vehicle is turned off.

Disconnect negative battery terminal for safety.
Remove existing stereo: Use removal tools for factory unit.
Connect wiring harness: Match colors (red=ignition, yellow=battery, black=ground).
Connect antenna plug to rear antenna input.
Connect speakers: Match polarity (+/-).
Slide unit into dash and secure with mounting sleeve.
Reconnect battery and test functions.

WARNING! Ensure proper grounding. Use fuse on power line. Do not short-circuit wires.

First-Time Setup

Power on unit; follow initial setup.

Set clock: Press CLOCK, use TUNE/SEEK to set time.
Program radio stations: Tune to station, press and hold preset button (1-6).
Adjust audio settings: Use BASS/TREBLE controls for preference.
Set loudness: Press LOUD for enhanced bass at low volumes.
Detach faceplate: Press RELEASE button and store securely.

CAUTION! Do not operate while driving. Park vehicle during setup.

Specifications

Tuner: FM 87.5-108 MHz, AM 530-1710 kHz.
CD Player: Anti-shock memory (10 sec), track repeat, random play.
Cassette: Frequency response 30-15,000 Hz, wow/flutter <0.15%.
Power Output: 50W x 4 max (17W RMS x 4).
Preamp Output: 2V front/rear.
Audio Controls: Bass ±10 dB, treble ±10 dB, balance/fader.
Power Supply: 12V DC (10.8-16V).
Dimensions: DIN size (178 x 50 x 160 mm).
Operating Temp: 0°C to 40°C (32°F to 104°F).

Controls and Settings

Front Panel: POWER/VOLUME knob, SOURCE (radio/CD/tape), BAND, TUNE/SEEK, BASS/TREBLE, LOUD, CLOCK, EJECT.

Remote: POWER, VOLUME, SOURCE, PRESET, TUNE, PLAY/PAUSE, STOP, SKIP.

Radio: Store presets (hold 1-6), seek/scan tuning. CD: PLAY, PAUSE, STOP, SKIP, REPEAT, RANDOM. Tape: PLAY, FF/REW, AUTO-REVERSE. Audio: BASS/TREBLE rotary controls, BALANCE/FADER via menu. Display: Dimmer (DIMMER button). Clock: Set via CLOCK button.

Connecting Devices

Antenna: Standard car antenna plug. Speakers: 4-8 ohm speakers. External amp: Use RCA preamp outputs.

Turn off vehicle before connecting.
Use proper gauge speaker wire (18 AWG recommended).
Connect preamp outputs to amplifier inputs (if used).
Select source via SOURCE button (TUNER, CD, TAPE).

Tip: Route wires away from power cables to reduce noise.

Playing Media

Supports audio CDs, CD-R/RW, cassette tapes.

Insert CD: Press EJECT, load CD label-up.
Play CD: Press PLAY; skip tracks with SKIP buttons.
Insert cassette: Open slot, insert tape with exposed side facing right.
Play tape: Press PLAY; auto-reverse engages at tape end.
Radio: Press BAND for FM/AM, TUNE/SEEK for stations.
Repeat/Random: Press RPT for track repeat, RDM for random play (CD).
FF/REW: Press and hold during tape play.
Anti-shock: Built-in memory protects against skipping.

WARNING! Do not use damaged discs/tapes. Keep slots free of debris.

Security Features

Detachable Faceplate: Press RELEASE to remove; store in carrying case. Code Security: Optional security code via menu (default 0000).

Care & Cleaning

Disconnect power before cleaning. Use soft, dry cloth for faceplate. Clean tape heads with cleaning cassette periodically.

CAUTION! Do not use solvents. Avoid moisture. Store faceplate in cool, dry place.

Regulatory Information

Troubleshooting

Symptom	Possible Cause	Corrective Action
No power	Wiring/fuse	Check battery connection; inspect fuse; verify ground.
No sound from speakers	Speaker wiring	Check speaker connections; ensure polarity correct.
CD not playing	Disc/loading	Ensure CD is clean, label-up; eject and reload.
Radio poor reception	Antenna	Ensure antenna fully extended and connected.
Tape won't play	Tape/dirty heads	Use known good tape; clean heads with cleaner.
Faceplate not attaching	Alignment	Align guides properly; press firmly until click.

Reset: Disconnect battery for 5 minutes to reset unit.

Service: 1-800-222-7669; www.sony.com/electronics/support